Getting The Best Swim Spa Cover

Swim Spas represent distinct difficulties when it concerns covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same reasons a hot tub needs a cover. The challenge is that because of the length of the swim spa and the height of the sides, removing and replacing the cover can be a lot more difficult.
Getting a brand-new swim spa is an amazing occasion in life. You’re eagerly anticipating the workout you’ll receive from using it. Perhaps you’re a little relieved to have actually lastly made a selection from the various designs you took a look at. At any rate, you most likely weren’t thinking much about the cover you would use.
Typically, the cover that gets home with your brand-new purchase will be a four section stiff foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it starts to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design flaw. Integrated in obsolescence due to the fact that as soon as it is placed in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper will not make any difference. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are very small as they rise from the water surface area. They make their method into the little cracks and crevices in the foam.

Then as the steam cools it forms back into a liquid and ends up being caught in the cover.
It happens gradually and on a Swim Spa Cover which is made of specific areas, at varying speeds. So eventually you’ll see a couple of of the areas are really getting heavy. The bar lifters on completions of the swim spa aren’t much help due to the fact that you still have to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com developed a different design for their Swim Spa Covers
Instead of using numerous foam panels to develop Swim Spa Covers that will eventually wind up in some landfill, they designed one that uses air chambers that do not suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or fall apart at the joints either. So if you own a swim spa, and you plan to keep using it daily, SpaCap.com has the cover for it.
If you’re not all set to purchase today, bookmark this site so you can find it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *